Anchor Shackles
» D-I-Y
From a usenet post by Philip the Foole:
Your dual anchor shackle idea works fine. I just tested it, and I’ve got them on right now, with a small padlock joining the two shackle pins, making the rig impossible to remove without the key to the padlock.
To make it work, you would need to have his balls relaxed and warm, so that they hang low away from the body. Otherwise, the rings are so close together that it isn’t possible to fit the cock in between them without pinching, which may or may not be desirable from your point of view.
This is pretty much exactly the setup used for several “male chastity belt” designs. All you need to add is a piece of PCV tube with a 45-degree bend from the plumbing department of your local hardware store. 1 1/4” diameter should be about right for the diameter. Drill a few holes in it around the base, slip it over his cock and lock the PVC tube to the two anchor shackles with a few small padlocks.
Alternatively, plastic cable ties could be used to make the connection. Now, he won’t be able to touch his cock, even with his hands free. This will be good for his self-discipline in the event he should be tempted by lustful thoughts while he is at work.
If you wish, you can “cap off” this rig with a PVC end cap, which you can glue on to the angle pipe. If you want him to be able to pee, you could drill a few holes in the end cap.
For an extra layer of security for a guy who has a cock piercing, a rod can be passed through the end of the tube to secure the piercing ring. There are several ways to secure such a rod. A hole drilled through the end, with a padlock through the hole, would be quite effective.
This can be constructed for *way* less than the professional “male chastity devices.”
You will need to experiment to find the correct sizes for the anchor shackles and PVC pipe to come up with a design that is reasonably comfortable. I just now built this rig in about ten minutes, and it works fine.
O-ring suitable for use as a cock ring
